Motion Pro 08-0550 Steering Head Bearing Race Driver Set

Worked perfectly for installing races on 2002 Honda Goldwing steering Head.

Clever tool with various sizes and tapers built into the ends of each driver. Nicely made and good quality.

I purchased this tool to complete the replacement of my Head Stock Bearings on my 2013 Triumph 800XC . The upper and lower Bearing Races end up recessed approximately 1/8-3/16” into the Head Tube . I was able and would recommend installing the new Races until they are flush with the Head Tube before using this Motion Pro tool . The 55-56mm attachment is the perfect size foe my application and allowed me to fully seat the Races with no damage . Perfect !

makes driving tapered bearing races a breeze

The product worked for my limited use of seating a couple races. However, after first use the soft aluminum material was marred on both the striking surface and the edges of the seating surfaces. I did not mishandle, just could be better if steel.

This tool is easy to use and does what it's meant to do. You could save money by using the old race as a driver, but this is easier and, if you have multiple bikes, good to have around.

Much more well made than the harbor freight version. The anodized coating wears off pretty easily, but it's a tool not artwork.

After trying to get by with other methods and failing I ordered this. I won't say how long or how much I sweated or how many curse words I put into installing the races on my 2007 Yamaha FJR before ordering this, but was quite pleased when on the third whack I heard the race fully seat itself. Should have just ordered it from the start.

This is the perfect tool for the job intended, don’t listen to all the reviews talking about marring the tool, they’re using steel hammers the aluminum tool. You’re supposed to use a cellulose tip hammer. (Hard rubber mallet) worked perfect installing the stem bearings on my vintage bike.