MG Chemicals413B-425G 413B Heavy Duty Flux Remover, 425g (14.90 oz) Aerosol Can

The product works. I'm not sure what else to write. I've used Flux Off professionally and it's good. I got this for my home lab to save a few bucks and I have no regrets. Cleans boards right up and doesn't leave them feeling sticky.

cleans flux as expected, remember to properly adjust nozzle to desired setting: "H M L"

This stuff is ridiculously effective at dissolving adhesives. The kind on stickers and tapes where you would otherwise spend an hour with a razor blade, this melts it off like nothing. It's so good I bet it's illegal in some states and probably causes cancer...but worth it.You definitely want to use this in a "well ventilated area". It's an extremely volatile solvent that lingers in the air.

A must have in any electronics lab

This is a strong defluxer! Cleans up with little residue. This will attack plastics so care must be taken around test equipment and whatever you are working on that has plastic housings or display covers. Very strong odor. I generally spray on a q-tip & apply to the area that needs cleaning. Lasts a long time that way & less chance of over spray.

Works good

It's OK, but it still leaves a sticky film behind on the PCBs that I have to go back over and clean off with alcohol.

Works great, good price. A little smelly.

My preferred board cleaner. Only thing I'd wish is they reduce the pressure. Always feels like it's shooting out more than I can scrub before it evaporates, and it tends to spray inadvertently at adjacent areas. e.g it would not be well suited to apply to q-tips, but it does well on large flat surfaces and when spraying into a microfiber towel to apply.

I feel like the old lady in the Franks Red Hot commercials because I put this Sh*t on everything. Very strong cleaner works great for removing thermal compound and ensuring a clean surface for reapplication. Just keep in mind it is not safe with all plastics or paints so be careful when using the stuff. Overspray on your nice new shiny computer or other expensive device doesn't make for the happiest cleaning experiences.One typical issue with MG Chemicals sprays is I really wish the low setting for the pressure was much lower, would help manage waste and keep it from being sprayed on things you don't want in a fine mist. The Label and Adhesive remover is absolutly horrible for this as you only need a tiny bit but the thing pumps it out like you just popped a hole in it, and that is low.

works