LUXE Bidet4 Piece Universal Non-Slip Toilet Seat Bumpers with Strong Adhesive

Needed them to raise the seat to use my bidet. Work great!

These work perfectly when you install a bidet attachment to a toilet. The bidet raises the seat level slightly and these bumpers compensate for that and keep the seat level.

Bought two sets of these for two Luxe bidets. One of the spacers fell off and won't stick back on. Very disappointed. Cleaned the surface before putting it on.Edit: I reached out to the company and they sent me a replacement set for free with very little trouble.

5 Star Product... 1 Star Install. Only issue I have with this is the requirement to use their model specific hardware. I had an older model Lux Bidet and thought it would be a simple switch out. WRONG! I had to re-run my hotwater line and swap out the old T pipe. Why? Because the new model's connections were 1mm different than the old model's. Very annoying install, but my derriere is happy with the new model. 😉

Most toilets will require them if you add Bedit. Glad I found them. Will be getting 8 more for other 2 toilets

These work fine as bumpers, however the instructions give very specific spots that you should put them on the seat. I was in a rush and not thinking, and now some of them are in terrible positions that make the seat slip downwards if you so much as slightly shift while sitting. You also cannot put one of the back ones on the spot it says if you have a LUXE bidet.On that note, it also drastically changes the "angle of attack" of the LUXE bidet. Before I got the bumpers the bidet hit the correct "spot" perfectly. Now, the bumpers push the seat up so much that the bidet does not hit the right spot anymore, requiring you to move around or lean forward. I figured since this was made by the same company as the bidet, it would be made for it, but it clearly is not.

Stuck safely on toilet seat with LUXE bidet unit

I have a few issues with these. I needed them because my luxe bidet I installed (which is great) wouldn’t let my seat go down all the way. I got these and they didn’t stick well at all. They ended up inadvertently falling off and getting flushed which I hope doesn’t cause any issues.It’s a poor design and definitely doesn’t work with all toilet seats. They need to be different heights, at least for my toilet seat, because if you place some towards the back and some towards the front, when you put the seat down, the ones on the back will touch first and the seat will still be hovering and when you sit it will put a lot of pressure on the seat which could break it. This caused my seat to be very unstable because it was only touching on the back (back as in further towards the tank).My toilet seat is curved on the bottom side which also causes some issues with these. These bumpers are too big to fit the underside well because of the curvature of my seat, so the grip was very weak. They held for a few days before giving out. Also, the grey padded part tore / ripped through on one of them before it fell off. Not built well at all.I would recommend getting these:Hibbent 10 Pieces Toilet Seat Bumpers, Universal Buffer Toilet Lid Rubber Bumpers Each One with 2 Thickness TPE Pads(2 Heights) Strong Adhesive Bidet Bumpers Used for Home, Hotel, Hospitalinstead. They’re cheaper, come with many more options, and they also allow you to adjust the height for each piece. They stick much, much better and the pieces are smaller (not shorter, just slightly smaller in width and length) which allowed me to put them in a place that actually helped my seat. Now my seat solidly touches the toilet and no longer hovers. These luxe ones were a waste of money and a bad design. I feel like it should be obvious that the ones you put near the back need to be shorter than the ones in the front, because the ones in the back will touch first otherwise. Bad design overall. Don’t get these and waste your money, get the other ones.